Back Door Courtesy Switch Circuit
Circuit diagnosis · Vehicles built Aug 2008 – Oct 2010
Versions by build date: Aug 2008 – Oct 2010 from Nov 2010
DESCRIPTION
The inner rear view mirror assembly receives the back door open/close signal from the back door courtesy switch.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING TECHSTREAM (LUGGAGE COURTESY SW) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Body / Data List /
According to the display on tester, read the "Data List".
Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Luggage Courtesy SW
Back door and back window courtesy switch signal/ON or OFF
ON: Either back door or back window open
OFF: Both back door and back window closed
-
- OK:
- Condition sign can be displayed.
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (BACK DOOR COURTESY SWITCH - INNER REAR VIEW MIRROR) |
![]() ![]() |
Disconnect the R6 inner rear view mirror connector.
Measure the resistance according value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R6-10 - Body ground
Back door is open
Below 1 Ω
R6-10 - Body ground
Back door is closed
10 kΩ or higher
Reconnect the R6 inner rear view mirror connector.
- HINT:
- The circuit has diodes, so reverse the two leads and check again.
|
|
||||
| OK | ||
| ||

