INSTALLATION
Removal / installation · Vehicles built Nov 2010 – Jul 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures described below are for the LH side.
| 1.
PRECAUTION |
 |
- CAUTION:
- Read "PRECAUTION" thoroughly before servicing (Click here).
| 2.
INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH |
 |
Install the curtain shield airbag assembly LH with the 13 bolts in the order shown in the illustration.


-
Torque:
- 9.8 N*m{
100 kgf*cm
, 7 ft.*lbf
}
- NOTICE:
- Do not twist the curtain shield airbag assembly LH when installing it.
Install the clip.
- Connect the connector to the curtain shield airbag assembly LH.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
| 3.
INSTALL ASSIST GRIP RETAINER LH |
 |
- Install the the assist grip retainer LH with the 2 bolts.
| 4.
INSTALL ROOF HEADLINING |
 |
- HINT:
- Refer to the procedures from "INSTALL ROOF HEADLINING" (Click here).
| 5.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
-
Torque:
- 3.9 N*m{
40 kgf*cm
, 35 in.*lbf
}
| 6.
PERFORM INITIALIZATION |
 |
Perform initialization (Click here).
- HINT:
- Some systems need initialization when disconnecting the cable from the negative battery terminal.
| 7.
INSPECT SRS WARNING LIGHT |
 |
Inspect the SRS warning light (Click here).