2011-2016 FJ Cruiser · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Aug 2012

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures described below are for the LH side.


1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).


2. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH

  1. Install the curtain shield airbag assembly LH with the 13 bolts in the order shown in the illustration.

    C128222E03

    Torque:
    9.8 N*m{ 100 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Do not twist the curtain shield airbag assembly LH when installing it.

  1. Install the clip.

  1. C141566
    Connect the connector to the curtain shield airbag assembly LH.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


3. INSTALL ASSIST GRIP RETAINER LH

  1. C128285
    Install the the assist grip retainer LH with the 2 bolts.


4. INSTALL ROOF HEADLINING

HINT:
Refer to the procedures from "INSTALL ROOF HEADLINING" (Click here).


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }


6. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    HINT:
    Some systems need initialization when disconnecting the cable from the negative battery terminal.


7. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).

← INSTALLATION (Nov 2010 – Jul 2012)DISPOSAL (Jul 2007 – Oct 2010) →