2011-2016 FJ Cruiser · Service Manual RESTRAINTS

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


INSPECT REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
  1. Perform a diagnostic system check (Click here).


INSPECT REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
  1. Perform a diagnostic system check (Click here).

  1. When the quarter panel of the vehicle or its area is damaged, check if there is any damage to the rear airbag sensor. If there are any defects as mentioned below, replace the rear airbag sensor with a new one:

    1. Cracks, dents or chips on the sensor housing.
    2. Cracks or other damage to the connector.
    3. Peeling off of the label or damage to the serial number.

    CAUTION:
    For rear airbag sensor removal and installation procedures, see pages Click here and Click here. Be sure to follow the correct removal and installation procedures.


INSPECT REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS DEPLOYED)

  1. C128248
    Replace the rear airbag sensor.

    CAUTION:
    For rear airbag sensor removal and installation procedures, see pages Click here and Click here. Be sure to follow the correct removal and installation procedures.

    HINT:
    The rear airbag sensor on the impacted side should be replaced after the curtain shield airbag assembly has deployed.

← COMPONENTS (from Nov 2010)ON-VEHICLE INSPECTION (from Nov 2010) →