P0604 Internal Control Module Random Access Memory (RAM) Error
Diagnostic trouble codes · Vehicles built from Nov 2010
Also covers:
- P0606 ECM / PCM Processor
- P060A Internal Control Module Monitoring Processor Performance
- P060B Internal Control Module A/D Processing Performance
- P060D Internal Control Module Accelerator Pedal Position Performance
- P060E Internal Control Module Throttle Position Performance
- P0657 Actuator Supply Voltage Circuit / Open
- P1607 Cruise Control Input Processor
Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010
DESCRIPTION
The ECM continuously monitors its internal memory status, internal circuits, and output signals transmitted to the throttle actuator. This self-check ensures that the ECM is functioning properly. If any malfunction is detected, the ECM sets the appropriate DTC and illuminates the MIL.The ECM memory status is diagnosed by internal "mirroring" of the main CPU and the sub CPU to detect Random Access Memory (RAM) errors. The 2 CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and sets a DTC if: 1) outputs from the 2 CPUs are different or deviate from the standards, 2) the signals sent to the throttle actuator deviate from the standards, 3) a malfunction is found in the throttle actuator supply voltage, or 4) any other ECM malfunction is found.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0604 P0606 P060A P060B P060D P060E P0657 P1607 |
ECM internal error (1 trip detection logic) |
ECM |
INSPECTION PROCEDURE
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.| 1. CHECK ANY OTHER DTCS OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the tester off.
Disconnect the tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menu items: Powertrain / Engine and ECT / DTC.
Read the DTC.
| Result |
Proceed to |
| DTC P0604, P0606, P060A, P060B, P060D, P060E, P0657 and/or P1607 are output |
A |
| DTC P0604, P0606, P060A, P060B, P060D, P060E, P0657, P1607 and other DTCs are output |
B |
| DTC is not output |
C |
|
|
||||
|
|
||||
| A | ||
| ||
