2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010

  1. Perform the RESET MEMORY (AT initialization) when replacing the automatic transmission assembly, engine assembly or ECM (Click here).
  2. If the ECM has been replaced or RESET MEMORY (AT initialization) has been performed, set up the function of the ATF (Automatic Transmission Fluid) temperature warning lamp (Click here).

1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

  1. B133854E02
    Disengage the claw and separate the glove compartment door stoppers from the glove compartment door.
    Text in Illustration 
    *1
    Stopper

  1. Slightly flex the upper part of the glove compartment door assembly to release the 2 stoppers and open the glove compartment door until it becomes horizontal.

  1. B271478
    Pull the glove compartment door assembly toward the rear of the vehicle to release the 3 hinges and remove the glove compartment door assembly.


2. REMOVE 4 WHEEL DRIVE CONTROL ECU NO.2 (for Automatic Transmission 4WD)

A226612
  1. Disconnect the connector.

  1. Remove the bolt and four wheel drive control ECU.


3. REMOVE ECM

  1. A226613
    Disconnect the 6 connectors.

  1. Remove the 3 nuts and ECM.


4. REMOVE ECM BRACKET

A226614
  1. Remove the 2 screws and ECM bracket.


5. REMOVE NO. 2 ECM BRACKET

A226615
  1. Remove the 2 screws and No. 2 ECM bracket.

← REMOVAL (Aug 2009 – Oct 2010)INSTALLATION (Jul 2007 – Jul 2009) →