2011-2016 FJ Cruiser · Service Manual BRAKE

C1421 Open or Short in Master Cylinder Pressure Sensor

Diagnostic trouble codes · Vehicles built from Aug 2012

Also covers:

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

C230327E01
DTC Code
DTC Detection Condition
Trouble Area
C1421
Either condition is met:
Both of the following conditions continue for at least 1.2 seconds.
  1. The IG1 terminal voltage is between 9.5 V and 17.0 V.
  2. The VM/C1 terminal voltage is not within 4.4 V and 5.6 V.
Both of the following conditions continue for at least 1.2 seconds.
  1. The VM/C1 terminal voltage is between 4.4 V and 5.6 V.
  2. The PM/C1 terminal voltage is not within 0.19 V and 4.57 V.
  1. Master cylinder pressure sensor circuit
  2. Master cylinder solenoid (Master cylinder pressure sensor, skid control ECU)
C1423
Both of the following conditions continue for at least 5 seconds
  1. The stop light switch is off.
  1. The PM/C1 terminal voltage is below 0.3 V.
C1424
One of the following conditions is met:
  1. Noise occurs in the signal from the PM/C1 terminal 7 times or more within 5 seconds
  2. When the vehicle speed drops from 40 km/h (25 mph) to 10 km/h (6 mph), the master cylinder pressure does not change by at least 0.048 MPa.
  3. At a vehicle speed of 7 km/h (4 mph) or more, the PM/C1 terminal voltage is between 0.86 and 1.0 V and master cylinder pressure does not change by at least 0.048 MPa for 60 seconds or more.
  4. At a vehicle speed of 7 km/h (4 mph) or more, the PM/C1 terminal voltage is 1.0 V or higher and master cylinder pressure does not change by at least 0.048 MPa for 30 seconds or more.
  5. At a vehicle speed of 7 km/h (4 mph) or more with the stop light switch ON, a state in which the master cylinder pressure sensor input value is sufficiently greater than the estimated master pressure continues for 1 second or more and this state occurs 5 or more times each time the ignition switch is turned to ON, and this occurs 8 or more times consecutively.
C1281
Stored only during test mode.

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


1. REPLACE MASTER CYLINDER SOLENOID
  1. Replace the master cylinder solenoid (Click here).


NEXT

END


← C1421 Open or Short in Master Cylinder Pressure Sensor (+ C1281, C1423, C1424) (Nov 2010 – Jul 2012)C1422 Master Cylinder Pressure Sensor Zero Point High Malfunction (Nov 2010 – Jul 2012) →