C1433 Steering Angle Sensor Internal Circuit
Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2011
Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
DESCRIPTION
Steering angle sensor signals are sent to the skid control ECU via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the steering angle sensor zero point malfunction diagnostic function.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1433 |
Either condition is met:
|
Steering angle sensor |
WIRING DIAGRAM
Refer to DTC C1432 (Click here).INSPECTION PROCEDURE
- HINT:
- When any of the speed sensors or the yaw rate and deceleration sensor has trouble, DTCs for the steering angle sensor may be stored even when the steering angle sensor is normal. When DTCs for the speed sensors or yaw rate and deceleration sensor are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and deceleration sensor first, and then inspect and repair the steering angle sensor.
- When any of the speed sensors or the yaw rate and deceleration sensor has trouble, DTCs for the steering angle sensor may be stored even when the steering angle sensor is normal. When DTCs for the speed sensors or yaw rate and deceleration sensor are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and deceleration sensor first, and then inspect and repair the steering angle sensor.
| 1. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Check for DTCs (Click here).
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
|
|
||||
| A | |
| 2. REPLACE STEERING ANGLE SENSOR |
Replace the steering angle sensor (Click here).
| NEXT | ||
| ||
