2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2014 from Aug 2014

HINT:
  1. The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock system is operating normally. Check the power door lock system first before troubleshooting the wireless door lock control system.
  2. Use these procedures to troubleshoot the wireless door lock control system.
  3. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.INSPECT MULTIPLEX COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN Communication System is functioning normally.

      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B


    B.
    A

    4.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B

    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. Data List/Active Test (Click here)

    3. On-vehicle Inspection (Click here)

    NEXT

    6.REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Nov 2010)HOW TO PROCEED WITH TROUBLESHOOTING (Nov 2010 – Jul 2014) →