2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2012

Versions by build date: Jul 2007 – Oct 2012 from Nov 2012


INSPECT FUEL SENDER GAUGE ASSEMBLY

  1. A294506E01
    Check that the float moves smoothly between the F level (upper end) and E level (lower end).
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Sender Gauge Assembly)

  1. Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Float position is F (Upper end)
    13.5 to 16.5Ω
    Float position is E (Lower end)
    405.5 to 414.5Ω

    If the value is not as specified, replace the fuel sender gauge assembly.

← INSPECTION (Jul 2007 – Oct 2012)INSTALLATION (Jul 2007 – Jul 2009) →