2011-2016 FJ Cruiser · Service Manual RESTRAINTS

B1000/31 Center Airbag Sensor Assembly Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2008

DESCRIPTION

The center airbag sensor assembly consists of parts including the airbag sensor, the safing sensor, the drive circuit, the diagnosis circuit, and the ignition control.
When the center airbag sensor assembly receives signals from the airbag sensor, it determines whether or not the SRS should be activated.
DTC B1000/31 is set when a malfunction is detected in the center airbag sensor assembly.
DTC No.
Detection Condition
Trouble Area
B1000/31
  1. Center airbag sensor assembly malfunction
  1. Center airbag sensor assembly

HINT:
When any other DTCs are set simultaneously with B1000/31, repair the malfunctions indicated by those DTCs first.


INSPECTION PROCEDURE


1. CHECK CENTER AIRBAG SENSOR ASSEMBLY

  1. H041086E15
    Turn the ignition switch off.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Clear any DTCs stored in the memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    OK:
    DTC B1000/31 is not output.



NG
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← DIAGNOSTIC TROUBLE CODE CHART (from Aug 2008)B1603/83 Front Satellite Sensor Bus RH Initialization Incomplete (+ B1612/83, B1613/83) (from Aug 2008) →