2011-2016 FJ Cruiser · Service Manual BODY

Power Windows do not Operate at All

Circuit diagnosis · Vehicles built Nov 2010 – Jul 2011

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2011 from Aug 2011

DESCRIPTION

If all of the power windows do not operate, the power window regulator master switch may have no power or may be malfunctioning.

WIRING DIAGRAM

B268479E01
B268479E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT POWER RELAY
B264911E02
  1. Remove the POWER relay from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Connection
    Specified Condition
    3 - 5
    Battery voltage not applied
    10 kΩ or higher
    3 - 5
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

  1. Reinstall the POWER relay.



NG
REPLACE POWER RELAY
OK


2. CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH - BATTERY AND BODY GROUND)

  1. B264903E04
    Disconnect the H5 or G8 power window regulator master switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for LHD 
    Tester Connection
    Switch Condition
    Specified Condition
    H5-9 (B) - Body ground
    Ignition switch ON
    11 to 14 V
    for RHD 
    Tester Connection
    Switch Condition
    Specified Condition
    G8-15 (B) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    H5-1 (E) - Body ground
    Always
    Below 1 Ω
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    G8-7 (E) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *A
    for LHD
    *B
    for RHD
    *a
    Front view wire harness connector
    (to Power Window Regulator Master Switch Assembly)

  1. Reconnect the master switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
  1. Inspect the power window regulator master switch assembly. (Click here)



NG
REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (Click here)
OK

REPLACE MAIN BODY ECU


← Power Windows do not Operate at All (Jul 2007 – Oct 2010)Power Windows do not Operate at All (from Aug 2011) →