2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Inner Rear View Mirror Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2008

DESCRIPTION

This is the power source circuit of the inner rear view mirror assembly.

WIRING DIAGRAM

E168295E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (INNER MIRROR - BATTERY AND BODY GROUND)

  1. E168297E02
    Disconnect the R6 inner rear view mirror assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R6-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R6-2 (E) - Body ground
    Always
    Below 1 Ω

  1. Reconnect the inner rear view mirror assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Display Signal Circuit between Inner Rear View Mirror Assembly and Television Camera Assembly (from Aug 2008)COMPONENTS (from Jul 2007) →