Display Signal Circuit between Inner Rear View Mirror Assembly and Television Camera Assembly
Circuit diagnosis · Vehicles built from Aug 2008
DESCRIPTION
This is the display signal circuit of the television camera assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (INNER MIRROR - TELEVISION CAMERA) |
Disconnect the R6 inner rear view mirror assembly connector.

Disconnect the c1 television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R6-7 (CV+) - c1-2 (CV+)
Always
Below 1 Ω
R6-13 (CGND) - c1-3 (CGND)
R6-14 (CB+) - c1-4 (CB+)
R6-6 (CV-) - c1-1 (CV-)
R6-7 (CV+) - Body ground
Always
10 kΩ or higher
R6-13 (CGND) - Body ground
R6-14 (CB+) - Body ground
R6-6 (CV-) - Body ground
Reconnect the inner rear view mirror assembly connector.
Reconnect the television camera assembly connector.
|
|
||||
| OK | |
| 2. INSPECT INNER REAR VIEW MIRROR ASSEMBLY |
Disconnect the c1 television camera assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
c1-4 (CB+) - c1-3 (CGND)
Ignition switch ON,
shift lever in R
5.5 to 7.05 V
Reconnect the television camera assembly connector.
|
|
||||
| OK | |
| 3. INSPECT TELEVISION CAMERA ASSEMBLY |
Using an oscilloscope, check the waveform.

Reference Tester Connection
c1-1 (CV-) - c1-2 (CV+)
Tester Range
0.2 V/DIV., 50 μs/DIV.
Vehicle Condition
Ignition switch ON,
shift lever in R
- OK:
- Waveform is as shown in the illustration.
|
|
||||
| OK | ||
| ||
