PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Nov 2010 – Jul 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012
Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| Noise |
1. Oil (level low) |
Click here
|
| 2. Oil (wrong) |
Click here
|
|
| 3. Transfer (faulty) |
Click here
|
|
| Oil leakage |
1. Oil (level too high) |
Click here
|
| 2. Gasket (damaged) |
Click here
|
|
| 3. Oil seal (worn or damaged) |
Click here
|
|
| 4. O-ring (worn or damaged) |
Click here
|
|
| Hard to shift or will not shift |
1. Shifting key spring (damaged) |
Click here
|
| 2. Synchronizer spring (worn or damaged) |
Click here
|
|
| Shift from HL to H impossible |
1. Indicator switch (for center differential lock position) |
Click here
|
| 2. Wire harness |
Click here
|
|
| 3. Skid control ECU with actuator |
Click here
|
|
| Shift from H to HL impossible |
1. Indicator switch (for center differential lock position) |
Click here
|
| 2. Wire harness |
Click here
|
|
| 3. Skid control ECU with actuator |
Click here
|
|
| Shift from H to LL impossible |
1. Indicator switch (for center differential lock position) |
Click here
|
| 2. Indicator switch (for LL position) |
Click here
|
|
| 3. Wire harness |
Click here
|
|
| 4. Skid control ECU with actuator |
Click here
|
|
| Shift from LL to H impossible |
1. Indicator switch (for center differential lock position) |
Click here
|
| 2. Indicator switch (for LL position) |
Click here
|
|
| 3. Wire harness |
Click here
|
|
| 4. Skid control ECU with actuator |
Click here
|