TERMINALS OF ECU
System information · Vehicles built from Nov 2010
Versions by build date: Jul 2007 – Jul 2008 Aug 2008 – Oct 2010 from Nov 2010
| TERMINALS OF ECU |


| *a |
Component without harness connected (Skid Control ECU) |
- |
- |
| Terminal No. (Symbol) |
Terminal Description |
| A4-1 (GND1) |
Skid control ECU ground |
| A4-2 (+BM1) |
Power supply for motor |
| A4-3 (FR+) |
Front right wheel speed sensor power supply output |
| A4-4 (FL-) |
Front left wheel speed sensor input |
| A4-5 (RR+) |
Rear right wheel speed sensor power supply output |
| A4-6 (RL-) |
Rear left wheel speed sensor input |
| A4-7 (STP) |
Stop light switch |
| A4-9 (CSW) |
VSC OFF switch |
| A4-11 (CANH) |
CAN communication terminal H |
| A4-12 (SP1) |
Speedometer signal |
| A4-13 (ATRC) |
A-TRAC switch*4 |
| A4-14 (P) |
Neutral start switch*1 |
| A4-16 (STPO) |
Stop light operation relay |
| A4-17 (FR-) |
Front right wheel speed sensor input |
| A4-18 (FL+) |
Front left wheel speed sensor power supply output |
| A4-19 (RR-) |
Rear right wheel speed sensor input |
| A4-20 (RL+) |
Rear left wheel speed sensor power supply output |
| A4-24 (TS) |
Sensor test terminal (Signal check switch) |
| A4-25 (CANL) |
CAN communication terminal L |
| A4-27 (EXI) |
L4 detection switch*1 LL detection switch*2 |
| A4-28 (PKB) |
Parking brake switch |
| A4-29 (EXI4) |
A.D.D. detection switch*1 Center differential lock detection switch*2 |
| A4-31 (+BS) |
Power supply for solenoid |
| A4-32 (GND2) |
Skid control ECU ground |
| A4-40 (EXI3) |
w/ Rear Differential Lock: Rear differential lock detection switch w/o Rear Differential Lock: IG power supply |
| A4-41 (LBL) |
Brake fluid level warning switch |
| A4-43 (NEO) |
Ground (Indicates 2WD or 4WD vehicle) |
| A4-45 (STP2) |
Stop light switch |
| A4-46 (IG1) |
IG1 power supply |
| A5-1 (IG2) |
IG2 power supply |
| A5-2 (+BM2) |
Power supply for motor (from battery) |
| A5-4 (GND3) |
Ground |
- *1: for Automatic Transmission
- *2: for Manual Transmission
- *3: w/ Rear Differential Lock
- *4: w/ A-TRAC
| TERMINAL INSPECTION |
- HINT:
- Voltage cannot be measured with the connector connected to the skid control ECU as the connector is water resistant.


| *a |
Front view of wire harness connector (Skid Control ECU) |
- |
- |
| Terminal No. (Symbols) |
Wiring Color |
Terminal Description |
Condition |
Specified Condition |
| A4-1 (GND1) - Body ground |
W-B |
Ground |
Always |
Below 1 Ω |
| A4-2 (+BM1) - Body ground |
L*6 L-Y*7 |
Power supply for motor (from battery) |
Always |
11 to 14 V |
| A4-7 (STP) - Body ground |
G-B |
Stop light switch |
Brake pedal depressed → released |
8 to 14 V → Below 1.5 V |
| A4-9 (CSW) - Body ground |
R-L |
VSC OFF switch |
VSC OFF switch off → on and held |
10 kΩ or higher → Below 1 Ω |
| A4-13 (ATRC) - Body ground*5 |
P-G |
A-TRAC switch input |
A-TRAC switch off → on and held |
10 kΩ or higher → Below 1 Ω |
| A4-14 (P) - Body ground*1 |
Y-B |
Neutral start switch |
Ignition switch ON shift P position → any shift position except P |
8 to 14 V → Below 1.5 V |
| A4-16 (STPO) - Body ground |
B-L |
Stop light operation relay |
Ignition switch off → ON |
Below 1 V → 11 to 14 V |
| A4-27 (EXI) - Body ground*1 |
W-L |
L4 detection switch |
Ignition switch ON Transfer condition L4 |
Below 1 V |
| Ignition switch ON Transfer condition except L4 |
11 to 14 V |
|||
| A4-27 (EXI) - Body ground*2 |
W-L |
LL detection switch |
Ignition switch ON Transfer condition LL |
Below 1 V |
| Ignition switch ON Transfer condition except LL |
11 to 14 V |
|||
| A4-28 (PKB) - Body ground |
W-R |
Parking brake switch |
Parking brake switch off → on |
10 kΩ or higher → Below 1 Ω |
| A4-29 (EXI4) - Body ground *1 |
GR |
ADD detection switch |
Ignition switch ON Transfer condition H4 or L4 |
Below 1.5 V |
| Ignition switch ON Transfer condition H2 |
11 to 14 V |
|||
| A4-29 (EXI4) - Body ground*2 |
GR |
Center differential lock detection switch |
Ignition switch ON Transfer condition LL or HL |
Below 1.5 V |
| Ignition switch ON Transfer condition H |
11 to 14 V |
|||
| A4-31 (+BS) - Body ground |
Y |
Power supply for solenoid (from battery) |
Always |
11 to 14 V |
| A4-32 (GND2) - Body ground |
W-B |
Ground |
Always |
Below 1 Ω |
| A4-40 (EXI3) - Body ground*3 |
L-Y |
Rear differential lock detection switch |
Ignition switch ON Rear differential lock switch ON |
Below 1.5 V |
| Ignition switch ON Rear differential lock switch OFF |
11 to 14 V |
|||
| A4-40 (EXI3) - Body ground*4 |
L-Y |
IG power supply |
Ignition switch off → ON |
Below 1 V → 11 to 14 V |
| A4-41 (LBL) - Body ground |
V-R |
Brake fluid level warning switch |
Brake fluid level +/-5 mm (+/-0.197 in.) from minimum level → maximum level |
Below 1 Ω → 1.9 to 2.1 kΩ |
| A4-43 (NEO) - Body ground |
P-L |
Ground |
Always |
Below 1 Ω |
| A4-45 (STP2) - Body ground |
G-Y |
Stop light switch |
Brake pedal depressed → released |
8 to 14 V → Below 1.5 V |
| A4-46 (IG1) - Body ground |
B-R |
IG1 power supply |
Ignition switch off → ON |
Below 1 V → 11 to 14 V |
| A5-1 (IG2) - Body ground |
B-O |
IG2 power supply |
Ignition switch off → ON |
Below 1 V → 11 to 14 V |
| A5-2 (+BM2) - Body ground |
L*6 L-Y*7 |
Power supply for motor (from battery) |
Always |
11 to 14 V |
| A5-4 (GND3) - Body ground |
W-B |
Ground |
Always |
Below 1 Ω |
- *1: for Automatic Transmission
- *2: for Manual Transmission
- *3: w/ Rear Differential Lock
- *4: w/o Rear Differential Lock
- *5: w/ A-TRAC
- *6: for RHD
- *7: for LHD