2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Back Sonar Sensor RH Circuit

Circuit diagnosis · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

CAUTION / NOTICE / HINT

HINT:
This procedure applies only for vehicles without rear fog lights.


DESCRIPTION

An ultrasonic sensor consists of a sensor portion that transmits and receives ultrasonic waves and a pre-amplifier that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and sends the received signals to the clearance warning ECU.

WIRING DIAGRAM

E148134E04

INSPECTION PROCEDURE


1. INSPECT NO. 1 ULTRASONIC SENSOR RH

  1. E160757E02
    Remove the No. 1 ultrasonic sensor RH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    12 to 16 kΩ

  1. Reinstall the No. 1 ultrasonic sensor RH.



NG
REPLACE NO. 1 ULTRASONIC SENSOR RH (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - NO. 1 ULTRASONIC SENSOR RH)

  1. E160758E02
    Disconnect the E31 clearance warning ECU connector.

  1. Disconnect the M1 No. 1 ultrasonic sensor RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E31-6 (S5) - M1-2 (S)
    Always
    Below 1 Ω
    E31-5 (E2) - M1-1 (E)
    Always
    Below 1 Ω
    E31-6 (S5) - Body ground
    Always
    10 kΩ or higher
    E31-5 (E2) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the clearance warning ECU connector.

  1. Reconnect the No. 1 ultrasonic sensor RH connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Back Sonar Sensor RH Circuit (Jul 2007 – Oct 2010)Clearance Sonar Main Switch Circuit (Jul 2007 – Oct 2010) →