Clutch switch circuit inspection is necessary for M/T vehicles. When the clutch pedal is released, the ECM receives the positive (+) battery voltage through the ECU-IG fuse and ignition switch. While the clutch pedal is depressed, the clutch switch assembly sends a signal to terminal D of the ECM. The ECM cancels cruise control when terminal D receives the signal (voltage of below 1 V).
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK HARNESS AND CONNECTOR (ECM - BATTERY)
Disconnect the E46 ECM connector.
Turn the ignition switch to the ON position.
Measure the voltage.
Standard voltage:
Tester Connection
Clutch Pedal Condition
Specified Condition
D(E46-21) - Body ground
Depressed
Below 1 V
D(E46-21) - Body ground
Released
11 to 14 V
Reconnect the ECM connector.
OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)