P0571 Stop Light Switch Circuit Malfunction
Diagnostic trouble codes · Vehicles built Aug 2009 – Oct 2010
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010
DESCRIPTION
The cruise control system cancels cruising when the ECM detects that the brake pedal is depressed during cruise control driving. The stop light switch assembly sends signals to the ECM according to the brake pedal conditions. When the brake pedal is released, terminal ST1- is the positive (+) battery voltage, and terminal STP voltage is below 1 V. While the brake pedal is depressed, terminal ST1- is below 1 V, and STP is positive (+) battery voltage. During braking, the ECM cancels cruise control as one of the manual cancel functions.The ECM outputs this trouble code when the voltage of terminals ST1- and STP are both below 1 V for 0.5 seconds or more at the same time.
The fail-safe function operates to enable normal driving even if there is a malfunction in the stop light signal circuit.
| DTC No. |
DTC Detected Conditions |
Trouble Areas |
| P0571 |
ECM detects a malfunction of the stop light switch circuit under both of the following conditions.
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT STOP LIGHT SWITCH OPERATION |
Check that the stop lights come on while the brake pedal is depressed, and go off when the brake pedal is released.
- OK:
Brake Pedal Condition
Stop Light Condition
Depressed
ON
Released
OFF
|
|
||||
| OK | |
| 2. INSPECT STOP LIGHT SWITCH ASSEMBLY |
Disconnect the stop light switch assembly connector.

Measure the resistance.
- Standard resistance:
Tester Connection
Switch Condition
Stop Light Condition
1 - 2
Switch pin free
(Brake pedal depressed)
Below 1Ω
3 - 4
Switch pin free
(Brake pedal depressed)
10 kΩ or higher
1 - 2
Switch pin pushed in
(Brake pedal released)
10 kΩ or higher
3 - 4
Switch pin pushed in
(Brake pedal released)
Below 1Ω
Reconnect the stop light switch assembly connector.
|
|
||||
| OK | |
| 3. INSPECT ECM (STP SIGNAL) |
Disconnect the E81 and E82 ECM connector.
Turn the ignition switch to the ON position.
Measure the voltage.
- Standard voltage:
Tester Connection
Brake Pedal Condition
Specified Condition
STP (E81-18) - Body ground
Depressed
11 to 14 V
STP (E81-18) - Body ground
Released
Below 1V
ST1- (E82-8) - Body ground
Depressed
Below 1V
ST1- (E82-8) - Body ground
Released
11 to 14 V
Reconnect the ECM connector.
|
|
||||
| OK | ||
| ||
