2011-2016 FJ Cruiser · Service Manual CRUISE CONTROL SYSTEM

P0571 Stop Light Switch Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010

DESCRIPTION

When the brake pedal is depressed, the stop light switch sends a signal to the ECM. Upon receiving the signal, the ECM cancels cruise control. Even if there is a malfunction in the stop light signal circuit while cruise control is in operation, normal driving is maintained due to a fail-safe function.
When the brake pedal is depressed, positive voltage is applied to terminal STP of the ECM through the STOP fuse and stop light switch, and the ECM cancels cruise control.
DTC Code
DTC Detection Condition
Trouble Area
P0571
The voltages of terminals ST1- and STP of the ECM are both below 1 V for 0.5 seconds or more.
  1. Stop light switch circuit
  2. Stop light switch assembly
  3. ECM

WIRING DIAGRAM

E216555E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - BATTERY)

  1. E216506E01
    Disconnect the A3 stop light switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A3-2 - Body ground
    Always
    11 to 14 V
    A3-4 - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Stop Light Switch Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT STOP LIGHT SWITCH ASSEMBLY

  1. B113724E12
    Remove the stop light switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Not pushed
    Below 1 Ω
    Pushed
    10 kΩ or higher
    3 - 4
    Not pushed
    10 kΩ or higher
    Pushed
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Stop Light Switch Assembly)
    *b
    Not Pushed
    *c
    Pushed



NG
REPLACE STOP LIGHT SWITCH ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (ECM - STOP LIGHT SWITCH ASSEMBLY)
  1. Disconnect the A3 stop light switch assembly connector.

  1. Disconnect the E81 and E82 ECM connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E82-8 (ST1-) - A3-3
    Always
    Below 1 Ω
    E81-18 (STP) - A3-1
    Always
    Below 1 Ω
    E82-8 (ST1-) - Body ground
    Always
    10 kΩ or higher
    E81-18 (STP) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← P0571 Stop Light Switch Circuit Malfunction (Aug 2009 – Oct 2010)P0575 Cruise Control Input Circuit (from Aug 2009) →