INSTALLATION
Removal / installation · Vehicles built Nov 2010 – Oct 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Oct 2012 from Nov 2012
| 1.
TEMPORARILY TIGHTEN FRONT UPPER SUSPENSION ARM |
 |
Install the upper arm and temporarily tighten the bolt, 2 washers and nut.
- Install the bracket with the bolt.
-
Torque:
- 8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
- Install the nut and a new clip.
-
Torque:
- 110 N*m{
1122 kgf*cm
, 81 ft.*lbf
}
| 2.
INSTALL SKID CONTROL SENSOR WIRE |
 |
Install the skid control sensor wire with the 2 bolts.
-
Torque:
- 13 N*m{
127 kgf*cm
, 9 ft.*lbf
}
| 3.
INSTALL FRONT WHEEL |
 |
-
Torque:
- 112 N*m{
1137 kgf*cm
, 82 ft.*lbf
}
| 4.
STABILIZE SUSPENSION |
 |
Lower the vehicle.
Bounce the vehicle up and down several times to stabilize the suspension.
| 5.
FULLY TIGHTEN FRONT UPPER SUSPENSION ARM |
 |
Fully tighten the nut.
-
Torque:
- 115 N*m{
1173 kgf*cm
, 85 ft.*lbf
}
| 6.
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
 |
(Click here)