2011-2016 FJ Cruiser · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Nov 2012

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Oct 2012 from Nov 2012


1. TEMPORARILY TIGHTEN FRONT UPPER SUSPENSION ARM

  1. G020153
    Install the upper arm and temporarily tighten the bolt, 2 washers and the nut.

  1. G020152
    Install the bracket with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. G020157
    Install the nut and a new clip.

    Torque:
    110 N*m{ 1122 kgf*cm , 81 ft.*lbf }


2. INSTALL SKID CONTROL SENSOR WIRE

C099168
  1. Install the skid control sensor wire with the 2 bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }


3. INSTALL FRONT WHEEL

Torque:
112 N*m{ 1137 kgf*cm , 82 ft.*lbf }


4. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.


5. FULLY TIGHTEN FRONT UPPER SUSPENSION ARM

G020158
  1. Fully tighten the nut.

    Torque:
    115 N*m{ 1173 kgf*cm , 85 ft.*lbf }


6. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← INSTALLATION (Nov 2010 – Oct 2012)COMPONENTS (from Jul 2007) →