2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built Jul 2007 – Jul 2009


INSPECT NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

G036152E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - 2
      33 to 39Ω at 20°C (68°F)

      If the result is not as specified, replace the vacuum switching valve No. 1.

  1. G036153E01
    Check the vacuum switching valve No. 1 for ground.

    1. Using an ohmmeter, measure the resistance between each terminal and the body.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 - Body
      10 kΩ or higher
      2 - Body
      10 kΩ or higher

      If the result is not as specified, replace the vacuum switching valve No. 1.

  1. FI06393E01
    Check the operation.

    1. Check that air does not flow from port E to port F.
      If the operation is not as specified, replace the vacuum switching valve No. 1.

    2. S004523E01
      Apply battery voltage across the terminals.

    3. Check that air flows from port E to port F.
      If the operation is not as specified, replace the vacuum switching valve No. 1.

← REMOVAL (Jul 2007 – Jul 2009)INSTALLATION (Jul 2007 – Jul 2009) →