2011-2016 FJ Cruiser · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with a painted surface.


3. REMOVE FRONT DOOR SCUFF PLATE

HINT:
Use the same procedure as for the RH side.


4. REMOVE FRONT FLOOR FOOTREST

  1. B130586
    Disengage the 4 claws and remove the front floor footrest.


5. REMOVE FOOTREST CLIP

  1. B130587
    Remove the 2 footrest clips.


6. REMOVE COWL SIDE TRIM BOARD

HINT:
Use the same procedure as for the RH side.


7. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP
  1. Separate the front door opening trim weatherstrip LH.


8. REMOVE INSTRUMENT PANEL NO. 1 REGISTER ASSEMBLY

  1. B133853
    Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.


9. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

  1. B133859
    Disengage the 3 claws and separate the hood lock control lever.


10. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY

  1. B133860
    Remove the 2 <F> bolts.

  1. Disengage the 5 clips and claw and remove the lower instrument panel finish panel.


11. REMOVE STOP LIGHT SWITCH
  1. Disconnect the stop light switch connector from the stop light switch.

  1. Turn the stop light switch counterclockwise and remove the stop light switch.


12. SEPARATE MASTER CYLINDER PUSH ROD CLEVIS

F050561
  1. Remove the clip and push rod pin and separate the push rod clevis.


13. REMOVE HYDRAULIC BRAKE BOOSTER

F051438E01
  1. Disconnect the 3 connectors from the hydraulic brake booster.

  1. C168977
    Using a union nut wrench, disconnect the 4 brake tubes from the hydraulic brake booster.

  1. C133114E01
    Use tags or labels to identify the place to reconnect each line.

  1. F050571
    Remove the 4 nuts and pull out the hydraulic brake booster.

  1. Remove the gasket from the hydraulic brake booster.


14. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

C225098
  1. Remove the bolt and the brake pedal support.


15. REMOVE BRAKE PEDAL RETURN SPRING

F050564
  1. Remove the return spring from the brake pedal support and brake pedal.


16. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
  1. Remove the stop light switch mounting adjuster from the brake pedal support.


17. REMOVE BRAKE PEDAL PAD
  1. Remove the brake pedal pad from the brake pedal.

← ON-VEHICLE INSPECTION (from Nov 2010)REMOVAL (Nov 2010 – Jul 2012) →