2011-2016 FJ Cruiser · Service Manual BRAKE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


INSPECT AND ADJUST BRAKE PEDAL

F043109E03
  1. Inspect the brake pedal height.

    Text in Illustration 
    *a
    Pedal height
    Pedal height from dash panel: 
    for LHD
    for RHD
    168.7 to 178.7 mm (6.642 to 7.035 in.)
    158.8 to 168.8 mm (6.252 to 6.645 in.)
    If the pedal height is incorrect, adjust the rod operating adapter length.

  1. Adjust the brake pedal height.

    1. Disconnect the connector from the stop light switch.

    2. Turn the stop light switch counterclockwise, and remove the stop light switch.

    3. Remove the hydraulic brake booster (Click here).

    4. C133078E01
      Loosen the clevis lock nut.

    5. Adjust the rod operating adapter length by turning the pedal push rod clevis.

      Rod operating adapter length A:
      201.7 to 202.7 mm (7.941 to 7.980 in.)

    6. Tighten the clevis lock nut.

      Torque:
      26 N*m{ 260 kgf*cm , 19 ft.*lbf }

    7. Install the hydraulic brake booster (Click here).

    8. F049043E17
      Insert the stop light switch into the adjuster until it just touches the brake pedal.
      Text in Illustration 
      *1
      Brake pedal
      *2
      Stop light switch mounting adjuster
      *3
      Stop light switch

      NOTICE:
      Do not depress the brake pedal.

    9. C133112E02
      Make a quarter turn clockwise to install the stop light switch.
      Text in Illustration 
      *1
      Shaft
      *2
      Stop light switch
      *a
      Stop light switch clearance

      NOTICE:
      Do not depress the brake pedal.

      HINT:
      The turning torque for installing the stop light switch:

      Torque:
      1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

    10. Check the stop light switch clearance.

      Stop light switch clearance:
      0.5 to 2.6 mm (0.020 to 0.102 in.)

    11. Connect the connector to the stop light switch.

  1. F048932E11
    Inspect the brake pedal free play.
    Text in Illustration 
    *a
    Pedal free play

    1. Stop the engine and depress the brake pedal several times until there is no vacuum left in the booster.

    2. Push in the pedal until the beginning of the resistance is felt. Measure the distance as shown.

      Pedal free play:
      1.0 to 6.0 mm (0.0394 to 0.236 in.)

      If incorrect, troubleshoot the brake system.

  1. R000934E29
    Inspect the brake pedal reserve distance.
    Text in Illustration 
    *a
    Pedal reserve distance

    1. Release the parking brake pedal.
      With the engine running, depress the pedal and measure the pedal reserve distance as shown.

      Pedal reserve distance from dash panel at 490 N (50 kgf, 110.2 lbf) 
      for LHD
      for RHD
      More than 56 mm (2.20 in.)
      More than 108 mm (4.25 in.)
      If incorrect, troubleshoot the brake system.

← ON-VEHICLE INSPECTION (Jul 2007 – Oct 2010)REMOVAL (Jul 2007 – Oct 2010) →