Remove the 4 clips and front fender apron seal RH from the front fender apron sub-assembly RH.
3.
REMOVE V-BANK COVER
Raise the front of the V-bank cover to disengage the 2 cushions of the V-bank cover from the 2 pins.
Text in Illustration
*1
Cushion
*2
Pin
*3
Hook
*4
No. 1 V-bank Cover Bracket
Disengage the 2 hooks to remove the V-bank cover from the No. 1 V-bank cover bracket.
4.
REMOVE FAN AND GENERATOR V BELT
While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ 6 mm (0.236 in.) into the service hole to fix the belt tensioner in place.
HINT:
The pulley bolt for the belt tensioner has a left-hand thread.
Remove the V belt.
5.
DRAIN POWER STEERING FLUID
6.
SEPARATE PRESSURE FEED TUBE ASSEMBLY
Disconnect the oil pressure switch connector.
Remove the bolt and the wire harness clamp bracket.
Remove the union bolt, then separate the pressure feed tube.
Remove the gasket from the pressure feed tube.
7.
SEPARATE NO. 1 OIL RESERVOIR TO PUMP HOSE
Disengage the clip and separate the No. 1 oil reservoir to pump hose.