DISASSEMBLY
Removal / installation · Vehicles built Jul 2007 – Jul 2009
Versions by build date: Jul 2007 – Jul 2009 from Aug 2009
| 1. FIX VANE PUMP |
![]() ![]() |
Using SST, fix the vane pump assembly in a vise.
- SST
- 09630-00014
(09631-00132)
- NOTICE:
- Do not over tighten the vise.
| 2. REMOVE POWER STEERING SUCTION PORT UNION |
Remove the bolt and suction port union.
Remove the O-ring from the suction port union.
| 3. REMOVE FLOW CONTROL VALVE |
Remove the pressure port union.
Remove the O-ring from the pressure port union.
Remove the flow control valve and compression spring.
| 4. REMOVE POWER STEERING OIL PRESSURE SWITCH |
- NOTICE:
- Be careful not to drop or badly damage the oil pressure switch. If damaged, replace it with a new one.
| 5. REMOVE VANE PUMP REAR HOUSING |
Remove the 4 bolts and vane pump housing rear from the vane pump housing front.
Remove the O-ring from the vane pump housing front.
| 6. REMOVE PULLEY SHAFT SUB-ASSEMBLY |
- NOTICE:
- Be careful not to drop or badly damage the pulley shaft. If damaged, replace it with a new one.
Using a screwdriver, remove the snap ring from the pulley shaft.
Remove the pulley shaft.
| 7. REMOVE VANE PUMP ROTOR |
Remove the 10 vane plates.
Remove the vane pump rotor.
| 8. REMOVE VANE PUMP CAM RING |
| 9. REMOVE VANE PUMP FRONT SIDE PLATE |
![]() ![]() |
Remove the side plate from the vane pump housing front.
Remove the O-ring from the side plate.
Remove the O-ring from the vane pump housing front.

| 10. REMOVE VANE PUMP HOUSING OIL SEAL |
![]() ![]() |
Using screwdriver, remove the oil seal.
- NOTICE:
- Be careful not to damage the vane pump housing front.



