2011-2016 FJ Cruiser · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


1. INSTALL CLUTCH DISC ASSEMBLY

C135774
  1. Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.

    SST
    09301-00220  

    NOTICE:
    Insert the clutch disc assembly in the correct orientation.


2. INSTALL CLUTCH COVER ASSEMBLY

C135776E02
  1. Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.

    Text in Illustration 
    *a
    Temporarily
    *b
    Matchmark

  1. Following the procedures shown in the illustration, tighten the 6 bolts, in the order starting with the bolt located near the knock pin on the top.

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    HINT:
    1. Following the order in the illustration, uniformly tighten the bolts.
    2. Move SST up and down, right and left lightly, after checking that the disc is in the center, and tighten the bolts.


3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

C135777
  1. Using a dial indicator with roller instrument, check the diaphragm spring tip alignment.

    Maximum non-alignment:
    0.5 mm (0.020 in.)

    If the alignment is not as specified, adjust the diaphragm spring tip alignment using SST.
    SST
    09333-00013  


4. INSTALL RELEASE FORK SUPPORT
  1. Install the release fork support onto the transaxle assembly.

    Torque:
    47 N*m{ 480 kgf*cm , 35 ft.*lbf }


5. INSTALL RELEASE BEARING HUB CLIP

6. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY

F050794E05
  1. Apply release hub grease to the release fork and release bearing assembly contact surfaces, release fork and push rod contact surface and release fork pivot point.

    Text in Illustration 
    V100135
    Release hub grease

    Grease:
    Toyota Genuine Release Hub Grease or equivalent

  1. Install the release fork onto the release bearing assembly.


7. INSTALL CLUTCH RELEASE BEARING ASSEMBLY

C137978E11
  1. Apply clutch spline grease to the input shaft spline.

    Text in Illustration 
    V100135
    Clutch spline grease

    Grease:
    Toyota Genuine Clutch Spline Grease or equivalent

    NOTICE:
    Do not apply grease to portion A shown in the illustration.

  1. Install the bearing onto the release fork, and then install them onto the transaxle assembly.

    NOTICE:
    After installation, move the fork forward and backward to check that the release bearing slides smoothly.


8. INSTALL MANUAL TRANSMISSION ASSEMBLY
(Click here)
← INSTALLATION (Jul 2007 – Oct 2010)PROBLEM SYMPTOMS TABLE (from Jul 2007) →