Removal / installation · Vehicles built Jul 2007 – Oct 2010
Versions by build date: Jul 2007 – Oct 2010from Nov 2010
1.
INSTALL CLUTCH DISC ASSEMBLY
Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.
SST
09301-00220
NOTICE:
Insert the clutch disc assembly in the correct orientation.
2.
INSTALL CLUTCH COVER ASSEMBLY
Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.
Following the procedures shown in the illustration, tighten the 6 bolts, in the order starting with the bolt located near the knock pin on the top.
Torque:
19 N*m{
195 kgf*cm
, 14 ft.*lbf
}
HINT:
Following the order in the illustration, uniformly tighten the bolts.
Move SST up and down, right and left lightly, after checking that the disc is in the center, and tighten the bolts.
3.
INSPECT AND ADJUST CLUTCH COVER ASSEMBLY
Using a dial indicator with roller instrument, check the diaphragm spring tip alignment.
Maximum non-alignment:
0.5 mm (0.020 in.)
If the alignment is not as specified, adjust the diaphragm spring tip alignment using SST.
SST
09333-00013
4.
INSTALL RELEASE FORK SUPPORT
Install the release fork support onto the transaxle assembly.
Torque:
47 N*m{
480 kgf*cm
, 35 ft.*lbf
}
5.
INSTALL RELEASE BEARING HUB CLIP
6.
INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY
Apply release hub grease to the release fork and release bearing assembly contact surfaces, release fork and push rod contact surface and release fork pivot point.
Sealant:
Toyota Genuine Release Hub Grease or Equivalent
Install the release fork onto the release bearing assembly.
7.
INSTALL CLUTCH RELEASE BEARING ASSEMBLY
Apply clutch spline grease to the input shaft spline.
Sealant:
Toyota Genuine Clutch Spline Grease or Equivalent
NOTICE:
Do not apply grease to portion A shown in the illustration.
Install the bearing onto the release fork, and then install them onto the transaxle assembly.
NOTICE:
After installation, move the fork forward and backward to check that the release bearing slides smoothly.