2011-2016 FJ Cruiser · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Jul 2007


INSPECT CLUTCH DISC ASSEMBLY

NOTICE:
When replacing the clutch disc assembly, make sure to perform an inspection of the flywheel sub-assembly and clutch cover assembly.

  1. F050787
    Using vernier calipers, measure the rivet head depth.

    Minimum rivet depth:
    0.3 mm (0.012 in.)

    If necessary, replace the clutch disc assembly.

  1. Install the clutch disc assembly onto the transaxle assembly.

    NOTICE:
    Insert the clutch disc assembly in the correct orientation.

  1. CL00373
    Using a dial indicator, check the clutch disc assembly runout.

    Minimum runout:
    0.7 mm (0.028 in.)

    If necessary, replace the clutch disc assembly.


INSPECT CLUTCH COVER ASSEMBLY

C135773E01
  1. Using vernier calipers, inspect the depth and width of wear of the diaphragm spring.

    Minimum:
    A (Depth): 0.5 mm (0.020 in.)
    B (Width): 6.0 mm (0.236 in.)

    If necessary, replace the clutch cover assembly.

  1. A272260E01
    Perform a visual inspection of the clutch cover assembly.

    1. Inspect for hair cracks or scratches extending from the center outwards, or discoloration.

    2. Inspect for hair cracks in a circular pattern, discoloration or excessive wear.

      Text in Illustration 
      *a
      Hair cracks, scratches or discoloration
      *b
      Hair cracks, discoloration or excessive wear
      If there is any damage, replace the clutch cover assembly.


INSPECT FLYWHEEL SUB-ASSEMBLY

  1. C307953E01
    Install the steel plate to the cylinder block or oil pan with the bolt, and set the magnetic base of the dial indicator against the steel plate.
    Text in Illustration 
    *a
    Steel Plate

  1. Using a dial indicator, inspect the flywheel sub-assembly runout.

    Maximum runout:
    0.1 mm (0.004 in.)

    If necessary, replace the flywheel sub-assembly.

  1. A272261E01
    Perform a visual inspection of the flywheel sub-assembly.

    1. Inspect for hair cracks or scratches extending from the center outwards, or discoloration.

    2. Inspect for hair cracks in a circular pattern, discoloration or excessive wear.

      Text in Illustration 
      *a
      Hair cracks, scratches or discoloration
      *b
      Hair cracks, discoloration or excessive wear
      If there is any damage, replace the flywheel sub-assembly.


INSPECT CLUTCH RELEASE BEARING ASSEMBLY

F050790
  1. Turn the release bearing by hand while applying force in the axial direction.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.
    If necessary, replace the release bearing assembly.

← REMOVAL (from Nov 2010)INSTALLATION (Jul 2007 – Oct 2010) →