2011-2016 FJ Cruiser · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Jul 2007


INSPECT OUTPUT SHAFT

F051607
  1. Using a cylinder gauge, measure the inside diameter of the output shaft.

    Standard inside diameter:
    45.017 to 45.025 mm (1.7723 to 1.7726 in.)

    Maximum inside diameter:
    45.025 mm (1.7726 in.)

    If the diameter exceeds the maximum, replace the output shaft.


INSPECT NO. 3 SYNCHRONIZER RING

F051608
  1. Using a feeler gauge, measure the clearance between the synchronizer ring and gear spline.

    Standard clearance:
    0.70 to 1.50 mm (0.0276 to 0.0591 in.)

    Minimum clearance:
    0.70 mm (0.0276 in.)

    If the clearance is less than the minimum, replace the synchronizer ring.

  1. F051609
    Coat the output shaft and synchronizer ring cone with gear oil. Check the braking effect of the synchronizer ring. Turn the synchronizer ring in one direction while pushing it to the gear cone. Check that the ring locks.

← DISASSEMBLY (from Jul 2007)REASSEMBLY (from Jul 2007) →