2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Stereo Component Amplifier Communication Error

Circuit diagnosis · Vehicles built from Nov 2010

INSPECTION PROCEDURE


1. IDENTIFY COMPONENT SHOWN BY SUB-CODE

  1. Enter diagnostic mode.E110917E19

  1. Press preset switch "2" to change the mode to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

    HINT:
    1. "P190" set by the radio receiver assembly is shown in the preceding illustration as an example.
    2. For details of the DTC display, refer to DTC Check/Clear (Click here).


NEXT


2. CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.If the power source circuit is operating normally, proceed to the next step.

    Component Table 
    Component
    Proceed to
    Radio receiver assembly (190)
    Radio receiver power source circuit (Click here)
    Multi-media interface ECU (388)
    Multi-media interface ECU power source circuit (Click here)


NEXT


3. INSPECT RADIO RECEIVER ASSEMBLY

  1. E194165E06
    Disconnect the E85*1 and F86 radio receiver assembly connectors.*1: w/ Stereo Component Amplifier Assembly

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    5 (ATX+) - 15 (ATX-)*1
    Always
    60 to 80 Ω
    9 (TXM+) - 10 (TXM-)
    Always
    60 to 80 Ω

    *1: w/ Stereo Component Amplifier Assembly
    Text in Illustration 
    *a
    Component without harness connected
    (Radio Receiver Assembly (w/ Stereo Component Amplifier Assembly))
    *b
    Component without harness connected
    (Radio Receiver Assembly)



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to Terminals of ECU (Click here).

  1. Referring to the following AVC-LAN wiring diagram, check the AVC-LAN circuit between the stereo component amplifier assembly and the component shown by the sub-code.

    1. Disconnect all connectors between the stereo component amplifier assembly and component shown by the sub-code.

    2. Check for an open or short in the AVC-LAN circuit between the stereo component amplifier assembly and component shown by the sub-code.

      OK:
      There is no open or short circuit.

      E194159E09



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a known good one and check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)
OK

END


← Radio Receiver Communication Error (from Nov 2010)Multi-media Interface ECU Communication Error (Nov 2010 – Jul 2012) →