2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Multi-media Interface ECU Communication Error

Circuit diagnosis · Vehicles built Nov 2010 – Jul 2012

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

INSPECTION PROCEDURE


1. IDENTIFY COMPONENT SHOWN BY SUB-CODE

  1. Enter diagnostic mode.E110917E19

  1. Press preset switch "2" to change to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

    HINT:
    1. "P190" set by the radio receiver assembly shown in the preceding illustration as an example.
    2. For details of the DTC display, refer to DTC Check/Clear (Click here).


NEXT


2. CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.If the power source circuit is operating normally, proceed to the next step.

    Component Table 
    Component
    Proceed to
    Radio receiver assembly (190)
    Radio receiver power source circuit (Click here)
    Stereo component amplifier assembly (440)*1
    Stereo component amplifier power source circuit (Click here)
    *1: w/ Stereo Component Amplifier Assembly


NEXT


3. INSPECT RADIO RECEIVER ASSEMBLY

  1. E194165E06
    Disconnect the E85*1 and F86 radio receiver assembly connectors.*1: w/ Stereo Component Amplifier Assembly

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    5 (ATX+) - 15 (ATX-)*1
    Always
    60 to 80 Ω
    9 (TXM+) - 10 (TXM-)
    Always
    60 to 80 Ω

    *1: w/ Stereo Component Amplifier Assembly
    Text in Illustration 
    *a
    Component without harness connected
    (Radio Receiver Assembly (w/ Stereo Component Amplifier Assembly))
    *b
    Component without harness connected
    (Radio Receiver Assembly)



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to Terminals of ECU (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the multi-media interface ECU and component shown by the sub-code.

    1. Disconnect all connectors between the multi-media interface ECU and component shown by the sub-code.

    2. Check for an open or short in the AVC-LAN circuit between the multi-media interface ECU and component shown by the sub-code.

      OK:
      There is no open or short circuit.

      E194159E09



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a known good one and check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

END


← Stereo Component Amplifier Communication Error (from Nov 2010)Multi-media Interface ECU Communication Error (from Aug 2012) →