2011-2016 FJ Cruiser · Service Manual COMMUNICATION SYSTEM

ECM Communication Stop Mode

Circuit diagnosis · Vehicles built Aug 2009 – Oct 2010

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010

DESCRIPTION

Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
  1. "Engine" not displayed on "BUS CHECK" screen of intelligent tester
  2. Applies to "ECM Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of ECM
  2. ECM main wire or connector
  3. ECM

WIRING DIAGRAM

E192052E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
  4. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK HARNESS AND CONNECTOR (+B2, +B, IGSW, E01)
  1. Turn the ignition switch off.

  1. E192050E01
    Disconnect the B50 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B50-14 (E01) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Rear view of wire harness connector
    (to ECM)

  1. Reconnect the ECM connector.

  1. E192051E02
    Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E82-22 (+B) - Body ground
    Ignition switch ON
    11 to 14 V
    E82-23 (+B2) - Body ground
    Ignition switch ON
    11 to 14 V
    E81-21 (IGSW) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *1
    Rear view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← ECM Communication Stop Mode (Jul 2007 – Jul 2009)ECM Communication Stop Mode (from Nov 2010) →