2011-2016 FJ Cruiser · Service Manual COMMUNICATION SYSTEM

ECM Communication Stop Mode

Circuit diagnosis · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010

DESCRIPTION

Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
  1. "ENGINE" not displayed on "BUS CHECK" screen of Techstream via CAN VIM
  2. Applies to "ECM COMMUNICATION STOP MODE" in "DTC combination table"
  1. Power source circuit of ECM
  2. ECM main wire or connector
  3. ECM

WIRING DIAGRAM

C132872E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

    HINT:
    Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK HARNESS AND CONNECTOR (+B2, +B, IGSW, E01)
  1. Turn the ignition switch OFF.

  1. C140798E01
    Disconnect the B1 ECM connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B1-7 (E01) - Body ground
    Always
    Below 1 Ω

  1. Reconnect the ECM connector.

  1. C140797E01
    Turn the ignition switch ON.

  1. Measure the voltage

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E47-1 (+B) - Body ground
    Ignition switch ON
    11 to 14 V
    E47-2 (+B2) - Body ground
    Ignition switch ON
    11 to 14 V
    E47-9 (IGSW) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← Yaw Rate Sensor Communication Stop Mode (from Nov 2010)ECM Communication Stop Mode (Aug 2009 – Oct 2010) →