2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Fuel Gauge Malfunction

Circuit diagnosis · Vehicles built Jul 2007 – Oct 2010

DESCRIPTION

The combination meter assembly controls the fuel receiver gauge in accordance with the resistance of the fuel sender gauge that varies depending on the fuel remaining amount in the fuel tank.

WIRING DIAGRAM

E126871E02

INSPECTION PROCEDURE


1. INSPECT HARNESS AND CONNECTOR
E126865E01
  1. Disconnect the L5 fuel sender gauge assembly connector.

  1. Check the meter indicator conditions.

Standard:
Tester Connection
Condition
Specified Condition
L5-2 - L5-3
Short circuit (Ignition switch ON)
Fuel gauge indicates "F" or more (Combination meter)

HINT:
This inspection creates an intentional short circuit between the connector terminals, to check the meter indicator operation.

NOTICE:
Perform the check quickly (within less than 10 seconds).

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L5-2 - Body ground
    Ignition switch ON
    4 to 7V

  1. Reconnect the fuel sender gauge assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT FUEL SENDER GAUGE ASSEMBLY

  1. Remove the fuel sender gauge assembly.E126882E01

  1. Check that the float position is between E and F.

  1. E126865E01
    Measure the resistance between terminals 2 and 3 of the fuel sender gauge connector.

    Standard resistance:
    Float Level
    Float Position (mm (in.))
    Specified Condition
    F
    77.3 (3.04) to 79.3 (3.12)
    14.7 Ω to 15.3 Ω
    1/2
    1.6 (0.05)
    212.5 Ω
    Warning
    34.8 (1.37)
    375.4 Ω
    E
    75.0 (2.95) to 77.0 (3.03)
    405 Ω to 415 Ω

  1. Reinstall the fuel sender gauge assembly.



NG
REPLACE FUEL SENDER GAUGE ASSEMBLY
OK


3. CHECK WIRE HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - FUEL SENDER GAUGE ASSEMBLY)
E126866E01
  1. Disconnect the E13 combination meter assembly connector.

  1. Disconnect the L5 fuel sender gauge assembly connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    E13-16 (L) - L5-2
    Below 1Ω
    E13-5 (E3) - L5-3
    Below 1Ω
    E13-16 (L) or L5-2 - Body ground
    10kΩ or higher
    E13-5 (E3) or L5-3 - Body ground
    10kΩ or higher

  1. Reconnect the combination meter assembly and fuel sender gauge assembly connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Tachometer Malfunction (from Aug 2011)Fuel Receiver Gauge Malfunction (Nov 2010 – Jul 2011) →