2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Engine Coolant Temperature Gauge Malfunction

Circuit diagnosis · Vehicles built Aug 2009 – Oct 2010

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010

DESCRIPTION

The combination meter assembly controls the engine coolant temperature gauge in accordance with engine coolant temperature signals from the ECM.

WIRING DIAGRAM

E148123E03

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (COOLANT TEMP)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List.

  1. According to the display on the tester, read the Data List.

    Engine and ECT 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Coolant Temp
    Engine coolant temperature:
    Min.: -40°C
    Max.: 140°C
    80 to 100°C (176 to 212°F)
    After warming up
    1. If value -40°C (-40°F): sensor circuit open
    2. If value 140°C (284°F): sensor circuit shorted

    Standard:
    Coolant temperature displayed on the tester is between 80°C (176°F) and 100°C (212°F) after warming up.



NG
GO TO SFI SYSTEM (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
  1. Disconnect the E13 combination meter assembly connector.

  1. Disconnect the E82 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E13-15 (TEMP) - E82-19 (THWO)
    Always
    Below 1 Ω
    E13-15 (TEMP) - Body ground
    Always
    10 kΩ or higher
    E82-19 (THWO) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the ECM connector.

  1. Reconnect the combination meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Engine Coolant Temperature Gauge Malfunction (Jul 2007 – Jul 2009)Engine Coolant Temperature Receiver Gauge Malfunction (Nov 2010 – Jul 2011) →