Engine Coolant Temperature Gauge Malfunction
Circuit diagnosis · Vehicles built Jul 2007 – Jul 2009
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010
DESCRIPTION
The combination meter assembly controls the engine coolant temperature gauge in accordance with engine coolant temperature signals from the ECM.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (COOLANT TEMP) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
According to the display on the tester, read the Data List.
Engine and ECT Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Coolant Temp
Engine coolant temperature:
Min.: -40°C
Max.: 140°C
80 to 100°C (176 to 212°F)
After warming up
- If value -40°C (-40°F): sensor circuit open
- If value 140°C (284°F): sensor circuit shorted
- OK:
- Coolant temperature displayed on the tester is between 80°C (176°F) and 100°C (212°F) after warming up.
- If value -40°C (-40°F): sensor circuit open
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM) |
Disconnect the E13 combination meter connector.
Disconnect the E46 ECM connector.
Measure the resistance.

- Standard resistance:
Tester Connection
Specified Condition
E13-15 (TEMP) - E46-14 (THWO)
Below 1 Ω
E13-15 (TEMP) or E46-14 (THWO) - Body ground
10kΩ or higher
Reconnect the ECM connector.
Reconnect the combination meter connector.
|
|
||||
| OK | ||
| ||
