2011-2016 FJ Cruiser · Service Manual BRAKE

C1203 ECM Communication Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014

DESCRIPTION

The circuit sends TRC, A-TRAC and VSC control information from the skid control ECU to the ECM, and engine control information from the ECM to the skid control ECU via the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
C1203
Information relating to engine drive source or destination stored in ECM does not match that stored in skid control ECU.
  1. CAN communication system
  2. ECM

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION LINE
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).

    OK:
    CAN Bus Check indicates no malfunctions in CAN communication.



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2. CHECK DTC (ENGINE CONTROL SYSTEM)
  1. Check if any DTC is recorded for the engine control system (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
REPLACE ECM (Click here)
A

GO TO ENGINE CONTROL SYSTEM (Click here)


← C1203 ECM Communication Circuit Malfunction (Nov 2012 – Jul 2014)C1203/53 ECM Communication Circuit Malfunction (Jul 2007 – Jul 2009) →