2011-2016 FJ Cruiser · Service Manual BRAKE

C1337 Diameter of the Tire is not Uniform

Diagnostic trouble codes · Vehicles built Aug 2011 – Jul 2012

Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012

DESCRIPTION

The skid control ECU measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing whether all 4 wheels are operating properly. Therefore, all wheel signals must be equal.
DTC Code
DTC Detection Condition
Trouble Area
C1337
When either of following conditions detected:
  1. Diameters different of 2 front wheels and 2 rear wheels.
  2. Wheel speed sensor fault
  1. Speed sensor
  2. Speed sensor rotor
  3. Speed sensor circuit
  4. Tire size
  5. Master cylinder solenoid (Skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

HINT:
When DTCs C1401 to C1416 are output with DTC C1337, inspect and repair the trouble areas indicated by DTCs C1401 to C1416 first (Click here).


1. CHECK TIRE SIZE
  1. Check tire size and condition of all 4 wheels.

    OK:
    Condition of all 4 wheels is normal and tire size is same.



NG
REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME IN SIZE
OK


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.

  1. Check if the same DTCs are output (Click here).

    HINT:
    Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C1337 Diameter of the Tire is not Uniform (Nov 2010 – Jul 2011)C1337 Diameter of the Tire is not Uniform (from Aug 2012) →