C1337 Diameter of the Tire is not Uniform
Diagnostic trouble codes · Vehicles built from Aug 2012
Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
DESCRIPTION
The skid control ECU measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing whether all 4 wheels are operating properly. Therefore, all wheel signals must be equal.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1337 |
When either of following conditions detected:
|
|
INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
- HINT:
- When DTCs C1401 to C1416 are output with DTC C1337, inspect and repair the trouble areas indicated by DTCs C1401 to C1416 first (Click here).
| 1. CHECK TIRE SIZE |
Check tire size and condition of all 4 wheels.
- OK:
- Condition of all 4 wheels is normal and tire size is same.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.
Check if the same DTCs are output (Click here).
- HINT:
- Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
