P0550 Power Steering Pressure Sensor Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2009
Also covers:
- P0552 Power Steering Pressure Sensor Circuit Low Input
- P0553 Power Steering Pressure Sensor Circuit High Input
DESCRIPTION
The power steering oil pressure switch (sensor) is turned ON when a power steering wheel load occurs by turning the steering wheel. The ECM regulates the engine idling RPM according to the voltage output of the sensor.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0550 |
Power steering oil pressure switch (sensor) voltage less than 0.28 V, or more than 4.9 V for 0.5 seconds while engine running. (1 trip detection logic) |
|
| P0552 |
Power steering oil pressure switch (sensor) voltage less than 0.28 V for 0.5 seconds while engine running. (1 trip detection logic) |
|
| P0553 |
Power steering oil pressure switch (sensor) voltage more than 4.9 V for 0.5 seconds while engine running. (1 trip detection logic) |
|
MONITOR DESCRIPTION
The ECM monitors the sensor voltage and uses this value to regulate the engine idling speed. When the sensor output voltage deviates from the normal operating range, the ECM determines that there is a malfunction in the power steering oil pressure sensor and stores a DTC.WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- If other DTCs relating to different systems that have terminal ETHW as the ground terminal are output simultaneously, terminal ETHW may have an open circuit.
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
- If other DTCs relating to different systems that have terminal ETHW as the ground terminal are output simultaneously, terminal ETHW may have an open circuit.
| 1. CHECK HARNESS AND CONNECTOR (ECM - POWER STEERING OIL PRESSURE SWITCH) |
Disconnect the ECM connector.
Disconnect the power steering oil pressure switch (sensor) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance (Check for Open):
Tester Connection
Condition
Specified Condition
B59-2 (PSP) - B48-16 (PSP)
Always
Below 1 Ω
B59-1 (VC) - B47-16 (VCV2)
Always
Below 1 Ω
B59-3 (E2) - B48-8 (ETHW)
Always
Below 1 Ω
- Standard Resistance (Check for Short):
Tester Connection
Condition
Specified Condition
B59-2 (PSP) or B48-16 (PSP) - Body ground
Always
10 kΩ or higher
B59-1 (VC) or B47-16 (VCV2) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. REPLACE POWER STEERING OIL PRESSURE SWITCH |
Replace the power steering oil pressure switch (Click here).
| NEXT | |
| 3. CONFIRM WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
Result Result
Proceed to
P0550, P0552 and/or P0553 are output
A
No DTC is output
B
|
|
||||
| A | ||
| ||
