P0505 Idle Control System Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2014 from Aug 2014
DESCRIPTION
The idling speed is controlled by the ETCS (Electronic Throttle Control System). The ETCS is comprised of: 1) the one valve type throttle body; 2) the throttle actuator, which operates the throttle valve; 3) the Throttle Position (TP) sensor, which detects the opening angle of the throttle valve; 4) the Accelerator Pedal Position (APP) sensor, which detects the accelerator pedal position; and 5) the ECM, which controls the ETCS. Based on the target idling speed, the ECM controls the throttle actuator to provide the proper throttle valve opening angle.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0505 |
Idling speed continues to vary greatly from target idling speed (2 trip detection logic) |
|
MONITOR DESCRIPTION
The ECM monitors the idling speed and idling air flow volume to conduct Idle Speed Control (ISC). The ECM determines that the ISC system is malfunctioning if the following conditions are met:- The learned idling air flow volume remains at the maximum or minimum volume for 5 seconds during a driving cycle.
- After driving at a vehicle speed of 10 km/h (6.25 mph) or more, the actual engine idling speed minus the target idling speed is less than -100 rpm or 150 rpm or more when the A/C is off and shift position is not neutral, or less than -100 rpm or 200 rpm or more when the A/C is on or shift position is neutral, 5 times or more during a driving cycle (w/o Secondary Air Injection System).


INSPECTION PROCEDURE
- HINT:
- The following conditions may also cause DTC P0505 to be stored:
- (1) The floor carpet overlapping slightly onto the accelerator pedal, causing the accelerator pedal to be slightly depressed and therefore the throttle valve position to be slightly open.
- (2) The accelerator pedal being not fully released.
- Read freeze frame data using the intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data, from the time the malfunction occurred.
- The following conditions may also cause DTC P0505 to be stored:
| 1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0505) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTCs.
Result Result
Proceed to
P0505 is output
A
P0505 and other DTCs is output
B
- HINT:
- If any DTCs other than P0505 are output, troubleshoot those DTCs first.
|
|
||||
| A | |
| 2. CHECK PCV HOSE CONNECTIONS |
Check the PCV hose connections.
- OK:
- PCV hose is connected correctly and is not damaged.
|
|
||||
| OK | |
| 3. CHECK INTAKE SYSTEM |
Check the intake system for vacuum leak.
- OK:
- No leak from intake system.
|
|
||||
| OK | |
| 4. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (THROTTLE VALVE) |
Check the throttle body with motor assembly condition.
- OK:
- Throttle valve is not contaminated with foreign objects and moves smoothly.
|
|
||||
| OK | ||
| ||
