2011-2016 FJ Cruiser · Service Manual SECURITIES

B2797 Communication Malfunction No. 1

Diagnostic trouble codes · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010

DESCRIPTION

This DTC is output when an error occurs in communication between the transponder key amplifier and the transponder key ECU.

HINT:
Some noise is found in the communication line.

DTC No.
DTC Detection Condition
Trouble Area
B2797
Keys are positioned too close to each other, or noise occurs in communication line
  1. Key
  2. Transponder key amplifier
  3. Transponder key ECU

WIRING DIAGRAM

B164251E17

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU assembly is replaced, register the key and ECU communication ID.


1. CHECK KEYS

  1. B072873E02
    Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether the key ring is in contact with the key grip.

    Result:
    Result
    Proceed to
    Key is near other keys and/or key ring is in contact with key grip.
    A
    Key is not near other keys and key ring is not in contact with key grip.
    B



B
Go to step 3
A


2. CHECK DTC OUTPUT
  1. Separate the keys from each other, or remove the key ring.

  1. Delete the DTCs (Click here).

  1. Insert a key into the ignition key cylinder and remove the key. Repeat for all the other keys of the vehicle.

    OK:
    No code is output.



NG
Go to step 3
OK

END

3. REPLACE TRANSPONDER KEY AMPLIFIER
  1. Replace the transponder key amplifier (Click here).


NEXT


4. CHECK ENGINE START
  1. Check that the engine starts.

    OK:
    The engine starts.



NG
REPLACE TRANSPONDER KEY ECU
OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)


← B2797 Communication Malfunction No. 1 (Aug 2009 – Oct 2010)B2799 Engine Immobiliser System Malfunction (Jul 2007 – Jul 2009) →