2011-2016 FJ Cruiser · Service Manual SECURITIES

B2780 Push Switch / Key Unlock Warning Switch Malfunction

Diagnostic trouble codes · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010

DESCRIPTION

This DTC will be output if the transponder key ECU does not detect that the unlock warning switch is ON even when the ignition switch is in the ON position. Under normal conditions, the unlock warning switch is ON when the ignition switch is in the ON position.
DTC No.
DTC Detection Condition
Trouble Area
B2780
"Unlock warning switch ON" is not detected when ignition switch is ON
  1. Wire harness
  2. Unlock warning switch
  3. Transponder key ECU

WIRING DIAGRAM

B151009E05

INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID.


1. READ VALUE USING INTELLIGENT TESTER
  1. Connect a intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester ON.

  1. Enter the following menus: Body Electrical / Immobiliser / Data List.

  1. According to the display on tester, read the "Data List".

Immobiliser: 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Key SW
Unlock warning switch signal/ON or OFF
ON: Key is in ignition key cylinder
OFF: No key is in ignition key cylinder
-

OK:
ON (Key is in ignition key cylinder) appears on the screen.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU

2. INSPECT UNLOCK WARNING SWITCH

  1. B175504E01
    Remove the unlock warning switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    1 - 2
    Switch pushed
    (Key set)
    Below 1 Ω
    Switch free
    (Key removed)
    10 kΩ or higher

  1. Reinstall the unlock warning switch.



NG
REPLACE UNLOCK WARNING SWITCH (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND)
  1. Disconnect the E21 unlock warning switch connector.

  1. B175505E01
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E21-2 - Body ground
    Always
    Below 1 Ω

  1. Reconnect the unlock warning switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - UNLOCK WARNING SWITCH)

  1. B175506E01
    Disconnect the E73 transponder key ECU connector.

  1. Disconnect the unlock warning switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E73-3 (KSW) - E21-1
    Always
    Below 1 Ω
    E21-1 - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the transponder key ECU connector.

  1. Reconnect the unlock warning switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU


← DIAGNOSTIC TROUBLE CODE CHART (from Nov 2010)B2780 Push Switch / Key Unlock Warning Switch Malfunction (Aug 2009 – Oct 2010) →