2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

DATA LIST / ACTIVE TEST

System information · Vehicles built Nov 2010 – Jul 2012

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012


READ DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Enter the following menus: Body / Main Body / Data List.

  5. According to the display on the tester, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ACC SW
    Ignition switch signal/ ON or OFF
    ON: Ignition switch ACC
    OFF: Ignition switch off
    -
    IG SW
    Ignition switch signal/ ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch ACC or off
    -
    Luggage Courtesy SW
    Back door and back window courtesy switch signal/ ON or OFF
    ON: Either back door or back window is open
    OFF: Both back door and back window are closed
    -
    D Door Courtesy SW
    Driver side door courtesy light switch signal/ ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -
    P Door Courtesy SW
    Passenger side door courtesy light switch signal/ ON or OFF
    ON: Passenger side door is open
    OFF: Passenger side door is closed
    -
    Rear Door Courtesy SW
    Rear door courtesy light switch signal/ ON or OFF
    ON: Rear door is open
    OFF: Rear door is closed
    -
    Passing Light SW
    Dimmer switch HIGH FLASH signal/ ON or OFF
    ON: Dimmer switch in HIGH FLASH (Pass)
    OFF: Dimmer switch not in HIGH FLASH (Pass)
    -
    Head Light SW (Head)
    Light control switch HEAD signal/ ON or OFF
    ON: Light control switch in HEAD
    OFF: Light control switch not in HEAD
    -
    Head Light SW (Tail)
    Light control switch TAIL signal/ ON or OFF
    ON: Light control switch in TAIL or HEAD
    OFF: Light control switch in neither TAIL nor HEAD
    -


PERFORM ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Enter the following menus: Body / Main Body / Active Test.

  5. According to the display on the tester, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Normal Condition
    Hazard
    Turn signal flasher
    ON/OFF
    -
    Head Light Relay
    Headlight Relay
    ON/OFF
    -
    Tail Light
    Taillight Relay
    ON/OFF
    -
    Illuminated Entry System
    Transponder key amplifier (Ignition key cylinder light)
    Room light and rear room light (Room lights switch is in DOOR position and all doors are closed)
    ON/OFF
    -

← DATA LIST / ACTIVE TEST (Jul 2007 – Oct 2010)DATA LIST / ACTIVE TEST (from Aug 2012) →