2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014


1. DRAIN ENGINE COOLANT

A070279E01

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.

  1. Remove the service hole cover from the engine under cover.

  1. Install a vinyl hose onto the drain on the radiator side.

  1. Fix the vinyl hose with tape.

  1. A076320E02
    Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.

  1. Remove the radiator cap.

  1. Drain the coolant from the reservoir tank.

  1. Tighten the 3 drain plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf } for the engine

  1. Remove the vinyl hose from the radiator.


2. REMOVE V-BANK COVER

A126474
  1. Remove the 2 nuts, then remove the V-bank cover.


3. REMOVE OIL FILTER SUB-ASSEMBLY

A076806E02
  1. Remove the drain pipe cap.

  1. While removing the oil filter with SST, catch the oil from the oil filter with a container.

    SST
    09228-07501  

  1. Install the drain pipe cap.

  1. A076322E02
    Clean the oil catch plate.

    HINT:
    When using a drain hose, perform the following procedures.

  1. Remove the drain pipe cap.

  1. Connect a drain hose to the oil filter bracket.

    HINT:
    1. Drain hose inside diameter: 8 mm (0.31 in.)
    2. Drain hose length: 900 mm (35.43 in.)

  1. Feed the drain hose down through the engine under cover, and put the drain oil container beneath the drain hose to catch the oil from the oil filter.

  1. A076323E02
    Using SST, remove the oil filter.
    SST
    09228-07501  

  1. Remove the drain hose and install the drain pipe cap.

  1. Clean the oil catch plate.


4. REMOVE OIL COOLER ASSEMBLY
  1. Disconnect the 2 hoses from the oil cooler.

  1. A076453E02
    Remove the union bolt, plate washer and oil cooler.

  1. Remove the O-ring from the oil cooler.


5. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY

A120414
  1. Remove the 2 nuts, 3 bolts, oil filter bracket and gasket.

← COMPONENTS (from Aug 2009)REMOVAL (Aug 2009 – Oct 2010) →