2011-2016 FJ Cruiser · Service Manual RESTRAINTS

B1625/22 Side Airbag Sensor LH Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2012

Also covers:

DESCRIPTION

The side collision sensor LH circuit (to determine deployment of the front seat airbag assembly LH and curtain shield airbag assembly LH) is composed of the airbag sensor assembly, side airbag sensor assembly LH and rear airbag sensor LH.
The side airbag sensor assembly LH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbag should be deployed.
DTC B1625/22 is stored when a malfunction is detected in the side airbag sensor assembly LH.
DTC No.
DTC Detection Condition
Trouble Area
B1625/22
B1627/82
  1. Side airbag sensor assembly LH malfunction
  2. Center airbag sensor assembly malfunction
  1. Side airbag sensor assembly LH
  2. Center airbag sensor assembly

WIRING DIAGRAM

Refer to DTC B1628/82 (Click here).

INSPECTION PROCEDURE

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).


1. CHECK SIDE AIRBAG SENSOR ASSEMBLY LH

  1. C267560E01
    Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Interchange the side airbag sensor assembly LH with RH and connect the connectors.

  1. Connect the cable to the negative (-) battery terminal.

  1. Clear the DTCs stored in memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC B1625/22 or B1627/82 output.
    A
    DTC B1620/21 or B1622/81 output.
    B
    DTCs B1620/21, B1622/81, B1625/22 and B1627/82 are not output.
    C

    HINT:
    Codes other than DTCs B1620/21 and B1625/22 may be output at this time, but they are not related to this check.

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Return the side airbag sensor assembly LH and RH to their original positions and connect the connectors.

    Text in Illustration 
    *1
    Side Airbag Sensor Assembly RH
    *2
    Center Airbag Sensor Assembly



B
REPLACE SIDE AIRBAG SENSOR ASSEMBLY LH (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)


← B1623/81 Driver Side - Side Airbag Sensor Assembly Initialization Incomplete (Nov 2010 – Jul 2012)B1625/22 Front Passenger Side - Side Airbag Sensor Malfunction (+ B1627/82) (Jul 2007 – Oct 2010) →