2011-2016 FJ Cruiser · Service Manual RESTRAINTS

B1620/21 Side Airbag Sensor RH Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2012

Also covers:

DESCRIPTION

The side collision sensor RH circuit (to determine deployment of the front seat airbag assembly RH and curtain shield airbag assembly RH) is composed of the center airbag sensor assembly, side airbag sensor assembly RH and rear airbag sensor RH.
The side airbag sensor assembly RH detects impacts to the vehicle and sends signals to the center airbag sensor assembly to determine if the airbag should be deployed.
DTC B1620/21 is stored when a malfunction is detected in the side airbag sensor assembly RH.
DTC No.
DTC Detection Condition
Trouble Area
B1620/21
B1622/81
  1. Side airbag sensor assembly RH malfunction
  2. Center airbag sensor assembly malfunction
  1. Side airbag sensor assembly RH
  2. Center airbag sensor assembly

WIRING DIAGRAM

Refer to DTC B1623/81 (Click here).

INSPECTION PROCEDURE

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).


1. CHECK SIDE AIRBAG SENSOR ASSEMBLY RH

  1. C267556E01
    Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Interchange the side airbag sensor assembly RH with LH and connect the connectors.

  1. Connect the cable to the negative (-) battery terminal.

  1. Clear the DTCs stored in memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC B1620/21 or B1622/81 output.
    A
    DTC B1625/22 or B1627/82 output.
    B
    DTCs B1620/21, B1622/81, B1625/22 and B1627/82 are not output.
    C

    HINT:
    Codes other than DTCs B1620/21 and B1625/22 may be output at this time, but they are not related to this check.

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Return the side airbag sensor assembly RH and LH to their original positions and connect the connectors.

    Text in Illustration 
    *1
    Side Airbag Sensor Assembly LH
    *2
    Center Airbag Sensor Assembly



B
REPLACE SIDE AIRBAG SENSOR ASSEMBLY RH (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)


← B161A/8A Lost Communication with Front Satellite Sensor Bus (from Aug 2012)B1620/21 Driver Side - Side Airbag Sensor Malfunction (+ B1622/81) (Jul 2007 – Oct 2010) →