2011-2016 FJ Cruiser · Service Manual RESTRAINTS

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Aug 2008

DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
The stored DTCs are indicated by the blinking patterns of the SRS warning light.

WIRING DIAGRAM

HINT:
When all the warning lights continue blinking, a ground short in the wiring of terminal TC of the DLC3 is suspected.

C192914E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (DLC3 - CENTER AIRBAG SENSOR ASSEMBLY)
  1. Turn the ignition switch off.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. C192915E01
    Disconnect the connector from the center airbag sensor assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E29-12 (TC) - E1-13 (TC)
    Always
    Below 1 Ω

  1. Reconnect the connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

  1. C192916E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (CENTER AIRBAG SENSOR ASSEMBLY - BODY GROUND)

  1. C148471E14
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E29-12 (TC) - Body ground
    Always
    1 MΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)


← SRS Warning Light does not Come ON (from Aug 2008)PRECAUTION (Jul 2007 – Oct 2010) →